Ultrasonic testing

> >>> Digital Ultrasonic Flaw Detector

Digital Ultrasonic Flaw Detector

HS Q6

The ultrasonic flaw detector is a device that can be used for the detection of many flaws in the materials. Flaw detection is an important process that is commonly used for various purposes. The most common use of flaw detection can be seen in various engineering works. The process is commonly employed in the detection of metal surfaces.

More details

More info

Features:
4.8 inch TFT screen, with 800*480 resolution, and 400cd brightness, clear display under high-light or low-light environment.
Complied with IP67 protection standard, not only waterproof and dustproof, but can work in water.
Advanced Joystick technology, realize one-bottom operation
Large SD storage space, with function to record the dynamic testing waveform and testing data of the whole testing process
With function of flaw detector and thickness gauge
With high performance Lithium battery, for long-time work
Measuring the defect height with diffraction signal of defect tips
Calculating the equivalent diameter of defects
Correcting the error caused by coved face
Spectrum analysis functions, with high speed FFT processing, able to measure the performance of transducer
With VGA interface, can connect projector
With high-speed USB 2.0 interface
The system can be upgraded directly via U disk.
With high resolution in near-field, suitable for flaw detection in thin-plate, composite material, metal and weld inspection.

Specifications

Sampling frequency

 200MHz / 10bit

Repetition frequency 

 25Hz、50Hz、100Hz、200Hz、500Hz、1000Hz

Damp match

 25Ω、50Ω、200Ω、500Ω

Frequency range

 0.5-4M、2-8M、10M、2-20M

Surplus sensitivity

 ＞60dB

Noise

 ≤10%

Probe mode

 single or dual transducer

Dynamic range

 ≥30dB

Li-battery supply

 more than 4 hours

Vertical linear error

 ≤3%

Horizontal linear error

 ≤0.1%

Excitation pulse

 minus square-wave, with 50-10μs width adjustable (step 10ns)

Size

 170mm×102mm×44mm

Weight

850g (Battery included)


Standard configuration：
1. One HS Q6 flaw detector (one lithium battery included)                
2. Two probe wires (C5-Q9)      
3. One power charge              
4. One set of communicate wire and data management software              
5. One instrument soft bag
6. One suitcase                 
7. One copy of manual, certificate and warranty card

20 other products you may be interested: